If you purchased ISPPRO, please refer to setting instructions for Ponyprog :
Setup --> Interface Setup. After setting as shown in setting in the figure, Probe and obtain OK. If you fail to obtain OK, you have to analyze the root cause.
First, press DELETE key turning on a computer again after shutting down it and access to CMOS setup as we usually do and set printer port in lot no. 0x378, LPT1 and interrupt IRQ7 in Peripheral menu.
And then, select Calibration in Setup and press [Yes] to obtain Calibration OK. Otherwise, you have to check because any problem can occur.
In Ponyprog, if you think the loading speed is slow, change configuration for quicker speed. File of PONYPROG2000.INI is created in the directory after installing PonyProg2000, which you can read the file using text editor and read it as memo pad.
You can change SPIBusSpeeed = NORMAL as FAST. And then, please set fuse and the like as below. Of course if you set just as Device ->AVRmicro->ATMEGA128 and then check Command -> Sequrity and Configuration bit, fuse.JPG page will appear.
Check just as shown in the screen, press Write and OK.
