Introduction of AD-USBISP+ V4.0 developing kit (for specialist)

- User can have a test downloading user’s created program on AVR ISP (In System Programming)developing kit and AVR internal program Memory(Supports Flash Read/Write)

- This kit can download all 8 bits AVR micro controller supporting ISP such as ATMEGA2560, ATMEGA2561, ATMega128, ATMega32, ATMega16 and ATMega8. (compatible with 3.3V/5V).

- This kit can be used for micro controller compatible with 8051 of 89S series such as AT89S52 and AT89S51.

- Supporting S/W (all kinds of lectures are available at http://www.NewTC.co.kr) is possible to download automatically after compiling in ICC-AVR.

- CodeVision C Compiler, Supports V1.24.6 Commercial Release and beyond (V1.24.7F is not supported).

- Stable working is available in V1.25.x version and higher. This kit supports all the newest version of AVR STUDIO (4.18 ~ 4.13).

Connecting AD-USBISP+ V04 with AB-M128Pro-A



ISP connecter PIN number



* In case of ATMega128, connect PDI and PDO to PIN 1 and PIN 2.
In case of AVR without PDI and PDO, connect MOSI and MISO.

* Function of PIN
- MOSI Master output Slave input > MISO Master input Slave

* output
- SCK Master clock out - RST Reset signal
- Vtref Target board voltage - NC Not Connect

How to Use Software

- Download USBISP V4.0 driver from data room on the website of NEWTC CO., LTD to install the software. Website is: http://www.newtc-en.com (Data center)

- Connect AD-USBISP+ V4.0 (hereinafter “USBISP”) to USB port on computer to search devices. USB Serial Port will be found in port device in systemhardwaredevice administrator in my computer as show in above figure. The result here is searched to be COM6, but ensure to check before using USBISP because the search result can be differ depending upon each computer or connected USB port.

* If change of COM port is needed, select USB Serial Port and press the right button on mouse to change COM port in propertyport settingadvanced->COM port number.