SE-3T9 serial cable(3P-9P DSUB) (120cm)
This is the serial cable to use when making RS-232 communication with NEWTC's AVR module,
AVR kit, AVR board, ARM kit, ARM module, FPGA kit etc.
How to use SE-3T9
Put 3 pin into 3 pin UART connecter of AM-128pro and 9 pin into DB-9 connecter which is RS-232 connecter of PC. In case there is no place to connect 9 pin in the note book, you can buy AD-USBERIAL V01 from NEWTC and put it to connect PC and AVR. This cable can be used because all the 3 pin connecters in NEWTC kit are same and uses same layout.
For AVR related with UART communication, refer to our webpage(http://www.NEWTC-en.com), and over there you could refer lectures & datacenter. In the lectures, you could see updated AVR lectures, and if you need some part of AVR lectures, then please leave a message in Q&A, and you could get the fast response from there. Also, you can find many source codes and circuits for that in data center.
Especially for UART communication, we prepared all the source code for several compiler( IAR EwAVR, ICCAVR V7, Codevision, WINAVR+AVR Studio). You can see this in datacenter or lectures.
- Picture of SE-3T9
|
